May 2006 - Manufacturer of the Month Products
Product Name: Double X-brace
Application: RSX/Civic SI
D3 Double X-Brace is without a doubt the BEST underbody brace for this application. With our superior design and use of advanced materials we have created another impressive track component. Tested on the track we have been able to greatly decrease understeer, virtually eliminate wheel hop, vastly improve steering response, and increase cornering speeds. Cusomters often mention that their cars now handle like go-karts! Material & Build: 304 Stainless Steel Tig Welded Raw finish Made in the USA.
Product Name: Full Chassis Stiffening Kit
Application: Eclipse/Stratus/Galant
This is the track pack! This kit has been proven to drop seconds off of your lap times when installed. This is also the same product we use on our Racecar Eclipse. When you install this kit you can consider your chassis rigid & solid! The overall effect of this kit can best be described as neutral, balanced, responsive, controlled, higher cornering speeds, torsional stiffness, and predictable. So if you are thinking about going fast around a turn make sure you have this kit installed on your car. This kit is the definition of CONTROL! All hardware is included and it can be installed in 45m minutes with common hand tools.
Product Name: Rear Chassis Brace
Application: Eclipse/Stratus/Galant
D3 Rear Chassis Brace will greatly increase the rear end stability of the vehicle by isolating the rear cross member. Given the large height of the rear cross member it is allowed to pivot, thus loosing valuable energy intended to go to the suspension. This product will help the back of the vehicle turn better! Material & Build: 304 Stainless Steel Tig Welded Raw finish Made in the USA
Product Name: Front Strut Tower Brace
Application: RSX Type-S
D3 does it again. We have produced an affordable FSTB-C for the Type-S that will out perform the designer brand strut bars. We have used the factory mounting points and added an additional mounting point on each side. Giving this component a total of (8) mounting points for maximum stiffness. Lightweight design and strong material makes this component another track star! Material & Build: 304 Stainless Steel Tig Welded Raw finish Made in the USA
Find a Retailer |
Information |
Images
|
